2022-05-30 TurboLink Firmware 1.3 - Bugfix: In impedance mode, no error is thrown if the data client sampling rate is higher than the control client rate. 2021-11-12 TurboLink Firmware 1.2 - The only changes in this release date compared to the one from 2021-10-28 are: a) "Data Client Rate" was renamed to "Data Client Transfer Rate" b) The checkbox label "Packet rate" was renamed to "Packeting" 2021-10-28 TurboLink Firmware 1.2 - Client data channel transfer rate The data transfer rate of the client interface can be reduced either by subsampling or by packetizing. - Reference channel output selection The web interface can be used to configure whether the selected reference channel contains the non-referenced data or zero. Firmware Installation Information: 1. Connect TurboLink to the PC as described in the TurboLink Setup Poster (steps 1 - 4). 2. Set fixed IP address for TurboLink on the Recorder PC to 192.168.5.1 3. Open TurboLink Setup Interface by opening a browser on the Recorder PC and go to 192.168.5.21:8000 4. Select „Firmware Update“ 5. Click on "Choose file" to select the update. This may take a while. 6. After selecting the file, click on "Install". The message “Installation of FIRMWARENAME succeeded." is shown. For questions, please contact techsup@brainproducts.com.