Wireless Trigger

Wireless Trigger
LiveAmp Wireless Trigger
TriggerBox with STE and Wireless Trigger for LiveAmp
  • Wirelessly transmits event markers to LiveAmp amplifiers

  • Fast and consistent trigger transmission

  • Encodes your stimulus events with 8-bit triggers

  • No software configuration necessary

Wireless Trigger: Wireless recording of event markers in EEG data

The Wireless Trigger provides a fully mobile solution for recording event markers in EEG data. Send 8-bit trigger information to a compatible amplifier wirelessly. Integrating this device into your lab is as easy as switching from the trigger cable to the Wireless Trigger – no software configuration required!

The set consists of a transmitter and a receiver. The transmitter is plugged into the parallel port of your stimulus PC or, even easier, into the TriggerBox output. The receiver is connected to the Sensor & Trigger Extension (STE) for LiveAmp, thereby replacing the original trigger cable. With this setup you can send 8-bit event markers from your stimulus presentation software wirelessly to the EEG amplifier.

This solution provides the fastest and most consistent wireless trigger timing. With a 3 millisecond transmission delay and only one sample jitter, it has the most accurate timing that is needed for gold standard EEG data analysis. it is the ideal companion for your mobile EEG recordings with our portable LiveAmp amplifiers.

Wireless TriggerTechnical specifications
Wireless data transmissionIn the 2.4 GHz ISM band. There are no restrictions for its use worldwide.
Radio frequency sensitivity- 104 dBm
Radio frequency output powerMax. 0 dBm
Wireless transmission rangeIndoor: Up to 10 m (depending on environment)
Trigger loss rateTypically < 1% (depending on environment)
DelayTypically 2.5 ±0.1 ms (depending on environment)
Jitter±1 sample point (depending on environment)
Minimum pulse width3 ms
Minimum duration between two subsequent triggers50 ms
Transmitter dimensions (W x D x H)16 mm x 59 mm x 57 mm
Transmitter weightApprox. 27 g
Receiver dimensions (W x D x H)16 mm x 59 mm x 35 mm
Receiver weightApprox. 20 g
Miscellaneous
Suitable for use in MR scanner roomNo
Medical deviceNo
CE markingBrain Products GmbH confirms the compatibility of this product according to the Directive 2014/53/EU (RED) of the European Parliament and the Council of 16 April 2014 on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment.

The Brain Products GmbH confirms the RoHS compliance of this product according to the Directive 2011/65/EU of the European Parliament and the Council of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment (recast published in the Official Journal of the European Union on 1 July 2011) as well as all its amendments up to and including the Commission delegated directive (EU) 2015/863 of 31 March 2015 (published in the 0fficial Journal of the European Union on 4 June 2015).

Recommended add-ons

LiveAmp

LiveAmp

LiveAmp Sensor & Trigger Extension (STE)

Sensor & Trigger Extension (STE) for LiveAmp

TriggerBox Plus

TriggerBox Plus